Paradyne 3800 User Manual page 155

COMSPHERE 3800 Series Modems
AT
Command
%Bn (cont'd) Modulation and Data Rate can also be set using S-register S41. The following
table shows the equivalent values of S41 for each %Bn value, and, where
applicable, %Bn in combination with Bn.
S41 = 20
S41 = 21
S41 = 1
S41 = 2
S41 = 3
S41 = 4
S41 = 5
S41 = 6
S41 = 7
S41 = 8
S41 = 10
S41 = 11
The factory default is %B19200.
%Cn MNP5 Data Compression
%C0 Disable.
%C1 Enable.
%Rn DTE Rate
Sets the rate at which data is passed between the modem and the DTE.
%R must be the last command on the command line. Setting the DTE rate with
the %R command does not turn off autobauding.
%R115200
%R76800
%R57600
%R38400
%R19200
%R14400
%R9600
%R7200
%R4800
%R2400
%R1200
%R300
Hn V.42bis Data Compression
H0 Disable.
H1 Transmit only.
H2 Receive only.
H3 Transmit and Receive.
14-14
Table 14-1
(12 of 12)
3800 Series AT Commands
Description
%B19200 V.32terbo, 19,200 bps
%B16800 V.32terbo, 16,800 bps
%B14400 V.32bis, 14,400 bps
%B12000 V.32bis, 12,000 bps
%B9600 V.32bis/V.32, 9600 bps
%B7200 V.32bis, 7200 bps
%B4800 V.32bis/V.32, 4800 bps
%B2400 V.22bis. 2400 bps
%B1200/B0 V.22, 1200 bps
%B1200/B1 Bell 212A, 1200 bps
%B300/B0 V.21, 300 bps
%B300/B1 Bell 103J, 300 bps
Sets the DTE rate to 115,200 bps.
Sets the DTE rate to 76,800 bps.
Sets the DTE rate to 57,600 bps.
Sets the DTE rate to 38,400 bps.
Sets the DTE rate to 19,200 bps.
Sets the DTE rate to 14,400 bps.
Sets the DTE rate to 9600 bps.
Sets the DTE rate to 7200 bps.
Sets the DTE rate to 4800 bps.
Sets the DTE rate to 2400 bps.
Sets the DTE rate to 1200 bps.
Sets the DTE rate to 300 bps.
September 1998
Front Panel
Branch
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
DTE Interface
Configure\Edit\
V42/MNP/Buffer
3810-A2-GB30-30