Paradyne 3800 User Manual page 159

COMSPHERE 3800 Series Modems
S-Register
S36 Rate Auto Originate
Initiates a dial backup call, using the phone number in directory
location 1, when the leased-line rate of the modem falls back to or below
a certain speed.
Register has the following values:
S36 = 0
S36 = 1
S36 = 2
S36 = 3
S36 = 4
S36 = 5
S36 = 6
NOTE: Rate Auto-Originate is valid only when V.32bis Autorate is
enabled (S76 = 0).
S37 Auto Redial (DTR)
Auto Redial allows repeated automatic dial backup attempts by
specifying the range of Directory Locations that can be tried. A redial
attempt is made in response to a bad phone number, a busy signal, no
answer, or no quiet answer. The modem must be in Originate mode.
When DTE Dialer Type is DTR=Dirs, Auto Redial works in conjunction
with the DTR Cont Repeat (S38) configuration option.
Register has the following values:
S37 = 0
S37 = 1
S37 = 2
S37 = 3
S
S
S37 = 9
NOTE: The modem must be in Originate mode to perform an automatic
dial backup.
S38 DTR Cont Repeat
Determines whether automatic dialing of dial backup directory locations
will be repeated continuously, or halted after the first pass.
Regardless of the setting of S38, dialing is locked out after ten failed
attempts to connect to the same number.
Register has the following values:
0 = Disable
1 = Enable
Factory setting is Disable.
14-18
Table 14-2
(4 of 12)
3800 Series S-Registers
Description
Disable
On fallback to 4800
On fallback to 7200
On fallback to 9600
On fallback to 12,000
On fallback to 14,400
On fallback to 16,800
Use Directory Location 1
Use Directory Locations 1–2
Use Directory Locations 1–3
Use Directory Locations 1–4
S S
S S
Use Directory Locations 1–10
September 1998
Front Panel Branch
Configure\Edit\Leased Line
Configure\Edit\Line_Dialer
(DTR Auto Redial)
Configure\Edit\DTE_Dialer
3810-A2-GB30-30