Paradyne 3800 User Manual page 158

S-Register
S18 Test Timeout
Register sets the duration (in seconds) for the modem tests. This
automatically cancels any test in progress after the time of this register
expires. Any test can be manually canceled by issuing the escape
sequence (+++) followed by the &T0 command.
Enter a value from 0 to 255 seconds. (A value of 0 disables this register.)
Factory setting is Disable (0).
S26 RTS-to-CTS Delay
Register sets the length of time (in 10-millisecond increments) the
modem waits after receiving RTS before issuing CTS to the DTE.
Enter a value from 0 to 255.
Factory setting is 0 milliseconds.
S34 1800 Hz Training Tone
This configuration option is for communication with certain modems that
do not comply with the V.32 standard. When 1800 Hz Training Tone is
enabled, a short burst of 1800 Hz (AC) tone is sent to the answering
modem to prompt it to answer. This is not required for V.32-compliant
modems.
Register has the following values:
0 = Disable
1 = Enable
Factory setting is Disable.
S35 Auto Redial (Leased Line)
Auto Redial allows repeated automatic dial backup attempts by
specifying the range of Directory Locations that can be tried. A redial
attempt is made in response to a bad phone number, a busy signal, no
answer, or no quiet answer. The modem must be in Originate mode.
On leased lines with dial backup, Auto Redial works in conjunction with
the Bad Lines Auto Originate and Rate Auto Originate options.
Register has the following values:
S35 = 0
S35 = 1
S35 = 2
S35 = 3
S
S
S35 = 9
NOTE: The modem must be in Originate mode to perform an automatic
dial backup.
3810-A2-GB30-30
Table 14-2
(3 of 12)
3800 Series S-Registers
Description
Use Directory Location 1
Use Directory Locations 1–2
Use Directory Locations 1–3
Use Directory Locations 1–4
S S
S S
Use Directory Locations 1–10
September 1998
AT Command Set and S-Registers
Front Panel Branch
Configure\Edit\Tests
Configure\Edit\DTE
Interface
Configure\Edit\Leased Line
Configure\Edit\Leased Line
(Auto Redial)
14-17