Safety Guidelines - Cisco ASR 9001 Hardware Installation Manual

Safety Guidelines

and scaling for each NPU as does the Cisco ASR 9001 Router. The following figure shows the front panel
of the Cisco ASR 9001-S Router.
Figure 2: Front Panel of the Cisco ASR 9001-S Router
In order to achieve the full bandwidth of 120 Gbps and to enable the disabled ports, a Cisco license can be
obtained. Once the license is obtained and installed, the Cisco ASR 9001-S Router must be reloaded to bring
up the full 120 Gbps capacity. For information on configuring the Cisco license for Cisco ASR 9001-S
Router, see the
Note The Cisco ASR 9001-S Router follows the same hardware installation procedure as the procedure for the
Cisco ASR 9001 Router, described in this document.
This chapter guides you through the process of preparing for router installation.
Before installing your Cisco ASR 9001 Router, you must consider these requirements:
• power and cabling requirements must be in place at your installation site
• special equipment must be available for installing the router
• the environmental conditions that your installation site must meet to maintain normal operation
The shipping package for the router is engineered to reduce chances of product damage that may result from
routine material handling during shipment:
• Keep the router in the shipping container until you have determined the installation site.
• The router should always be transported or stored in its shipping package in the upright position.
Inspect all items for shipping damage. If an item appears damaged, contact a Cisco customer service
representative immediately.
This chapter contains these installation topics:
•
•
•
Safety Guidelines
Before you perform any procedure in this publication, you must review the safety guidelines in this section
to avoid injuring yourself or damaging the equipment.
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
2
Cisco ASR 9001-S 120G Upgrade License Configuration Guide
Safety Guidelines, page 2
Site Requirement Guidelines, page 5
Cisco ASR 9001 Router Port Connection Guidelines, page 23
Preparing for Installation
.