Ap Management; Figure 51: Valid Access Point Configuration - D-Link DWC-1000 User Manual

Wireless Controller

4.7 AP Management

Valid Access Point Configuration
Setup > AP Management > Valid AP
MAC Address This field shows the MAC address of the AP. To change this field,
you must delete the entire Valid AP configuration and then enter the correct MAC
address from the page that lists all Valid Aps
Location: To help you identify the AP, you can enter a location. This field accepts
up to 32 alphanumeric characters
AP Mode You can configure the AP to be in one of three modes:
• Standalone: The AP acts as an individual access point in the network.
• Managed: If an AP is in Managed Mode, the Administrator Web UI and SNMP
services on the AP are disabled.
• Rogue: Select Rogue as the AP mode if you wish to be notified (through an SNMP
trap, if enabled) when this AP is detected in the n etwork.
Profile: If you configure multiple AP Profiles, you can select the profile to assign
to this AP

Figure 51: Valid Access Point Configuration

83
User Manual