Figure 52: Add A Valid Access Point - D-Link DWC-1000 User Manual

Wireless Controller
This page has the following buttons :
• Edit - To edit AP details in Valid AP pa ge.
• Delete - To delete a valid AP provide valid MAC address in Valid AP page.
• Add - To add an AP in Valid AP page.

Figure 52: Add a Valid Access Point

MAC Address: This field shows the MAC address of the AP. To change this fi eld,
you must delete the entire Valid AP configuration and then enter the correct MAC
address from the page that lists all Valid APs.
AP Mode: You can configure the AP to be in one of three modes:
• Standalone: The AP acts as an individual access point in the network. You do not
manage the AP by using the controller. Instead, you log on to the AP itself and
manage it by using the Administrator Web User Interface (UI), CLI, or SNMP. If
you select the Standalone mode, the screen refreshes and different fields appear. For
Standalone mode the following fields are enabled Expected SSID, Expected
Channel, Expected WDS Mode, Expected Security Mode and Expected Wired
Network Mode.
• Managed: The AP is part of the D -Link Wireless Controller, and you manage it by
using the Wireless Controller. If an AP is in Managed Mode, the Administrator Web
UI and SNMP services on the AP are disabled.
• Rogue: Select Rogue as the AP mode if you wish to be notified (through an SNMP
trap, if enabled) when this AP is detected in the n etwork. Additionally, the when
this AP is detected through an RF scan, the status is listed as Rogue. If you select
the Rogue mode, the screen refreshes, and fields that do not apply to this mode are
hidden.
84
User Manual