Configuring Vpn Clients; Pptp / L2Tp Tunnels; Pptp Tunnel Support - D-Link DWC-1000 User Manual

Wireless Controller

6.3 Configuring VPN clients

Remote VPN clients must be configured with the same VPN policy parameters used in
the VPN tunnel that the client wishes to use: encrypti on, authentication, life time, and
PFS key-group. Upon establishing these authentication parameters, the VPN Client
user database must also be populated with an account to give a user access to the
tunnel.

VPN client software is required to establish a VP N tunnel between the controller
and remote endpoint. Open source software (such as OpenVPN or Openswan) as
well as Microsoft IPsec VPN software can be configured with the required IKE
policy parameters to establish an IPsec VPN tunnel. Refer to the client software
guide for detailed instructions on setup as well as the controller's online help.
The user database contains the list of VPN user accounts that are authorized to use a
given VPN tunnel. Alternatively VPN tunnel users can be authenticated using a
configured Radius database. Refer to the online help to determine how to populate the
user database and/or configure RADIUS authentication.

6.4 PPTP / L2TP Tunnels

This controller supports VPN tunnels from either PPTP or L2TP ISP servers. The
controller acts as a broker device to allow the ISP's server to create a TCP control
connection between the LAN VPN client and the VPN server.

6.4.1 PPTP Tunnel Support

Setup > VPN Settings > PPTP > PPTP Client
PPTP VPN Client can be configured on this controller. Using this client we can
access remote network which is local to PPTP server. Once client is enabled, the
user can access
clicking Connect. To disconnect the tunnel, click Drop.
Status > Active VPNs
125
page and establish PPTP VPN tunnel
User Manual