World Wide Node Name Configuration - HP M2402 User Manual

Serial/Telnet User Interface

World Wide Node Name Configuration

In the Configuration Menu, select World Wide Node Name Configuration (3) to
change the values for the Fibre Channel World Wide Node Name.
illustration of the World Wide Node Name Settings menu.
Figure 73: Worldwide Node Name Setting menu
Note:
be compliant with IEEE Fibre Channel Format 1, where the left-most hexadecimal
character (the NAA field) of the WWN is '1'. Additionally, the sixth hexadecimal value
from the right must be a value of '0' or'1'.
To change the World Wide Name, select the appropriate Change Fibre Channel
World Wide Node Name option (1) or (2).
Note:
settings will be overwritten.
118
For Controller LUN commands to be operational, WWN naming schemes MUST
Caution: Changing the WWN Name could result in duplicate names on a
single Storage Area Network (SAN). It is recommended to use the default
values for World Wide Names.
If the Configuration Settings are reset to the factory defaults, these customized
Network Storage Router M2402 User Guide
Figure 73 is an