HP M2402 User Manual page 94

Visual Manager User Interface
Note:
Note:
use Fibre Channel devices. This type of configuration is known as a Target Mode
configuration.
Note:
complete their individual power-ups.
76
Target ID(s) adds or removes Target IDs.
Caution: If this configuration setting is incorrectly set, processing difficulties
may occur. Before changing this setting, evaluate the need for the change and
verify the desired setting. HP recommends backing up the router configuration
to an external file before making changes to this setting.
Target IDs must be set up prior to mapping devices on the SCSI bus.
Do not enable Target IDs unless there is a SCSI initiator on the bus that wants to
Discovery toggles between Enabled and Disabled.
Discovery Delay is the wait time after a power-up or reboot before
discovering SCSI devices.
HP recommends setting the value to at least 2 seconds to ensure all SCSI devices
Bus Reset on Boot toggles between Enabled and Disabled.
When enabled, the router will automatically reset SCSI buses during a power
up or reboot of the router.
Internal Termination toggles between Enabled and Disabled.
Caution: If this configuration setting is incorrectly set, processing difficulties
may occur. Before changing this setting, evaluate the need for the change and
verify the desired setting. HP recommends backing up the router configuration
to an external file before making changes to this setting.
When enabled, allows internal termination of the selected SCSI bus. When
disabled, the SCSI Bus, not the router handles SCSI termination.
Network Storage Router M2402 User Guide