Setting Port Name Information; Setting Snmp Trap Ip Addresses - HP M2402 User Manual

4. Do a SET operation on the connUnitName leaf, making sure to use the
5. Repeat these steps for each connUnitInfo, connUnitContact, and

Setting Port Name Information

HP recommends naming ports based on the type of device that is connected to that
port. For example, a port connected to a terabyte RAID storage array could be
named something to reflect this identity.
To name a port:
1. Access the Fibre Alliance MIB.
2. Go to the connUnitPortTable leaf.
3. Scroll to the connUnitPortName leaf.
4. Do a SET operation on the connUnitPortName leaf, making sure to use the

Setting SNMP Trap IP Addresses

The router allows configuration of up to three network managers, with different
filtering levels on each manager. Each network management station receives
event traps about unit, port, and sensor changes. These traps can be monitored by
various applications, including Computer Associates SANiti
SANinsite
To set up an IP address for a network manager:
1. Access the Fibre Alliance MIB.
2. Go to the trapReg leaf.
3. Do a WALK of the leaf to see how many open slots are available in the
4. Go to the trapRegRowState leaf in the trapRegTable.
5. Set the Object Identifier (OID) to the IP address and port number.
Network Storage Router M2402 User Guide
community SET string shown in the Serial/Telnet SNMP Configuration
Menu.
connUnitLocation.
community SET string shown in the Serial/Telnet SNMP Configuration
Menu.
TM
.
trapClientAccount leaf. There should be less than three.
This sets an IP address with a default filter value of 6 (which corresponds to
warning events) and includes events for all values of 5 and below.
The value entered for the port number must be an integer in the range of 1 to
65,535.
SNMP Management Information Bases
TM
and Vixel
223