Hardware Module Replacement
Figure 129: Thumbscrews and handle on a Fibre Channel module
4. To install the new module, hold the handle 2 shown in
5. Tighten the thumbscrews on the new I/O module or blank module until
194
Figure
129, align the bottom plate of the module beneath the guides of the bay
opening, and slide the new module into the bay opening until the outer plate
of the module is flush against the back-side of the router.
Caution:
When installing a module, ensure the edges of the bottom plate of
the module are beneath the guides of the bay opening. Failure to properly
install a module may result in damage to the module or router and may void
your service warranty.
secure.
1
2
Figure 128
Network Storage Router M2402 User Guide
or