HP M2402 User Manual page 95

Network Storage Router M2402 User Guide
Buffered Tape Writes (default: Enabled) toggles between Enabled and
Disabled.
When enabled, Buffered Tape Writes enhance system performance. Buffered
Tape Writes return status on consecutive write commands prior to the tape
device receiving data.
Default Map (default: auto-assigned) sets the current mapping mode for the
selected bus.
If this configuration setting is incorrectly set, processing difficulties
Caution:
may occur. Before changing this setting, evaluate the need for the change and
verify the desired setting. HP recommends backing up the router configuration
to an external file before making changes to this setting.
The current map can be set to:
— Indexed
— Auto-assigned (default) contains all the devices attached to the router.
— SCC
For more information about mapping modes, see
Methods and Table Structures."
For information on changing map entries, see "Mapping Menu" later in this
chapter.
Override Settings: To override the settings of a SCSI target, select a Target
ID icon with the appropriate Target ID number.
After a specific Target is selected, the SCSI Override sub-screen is displayed
and is used to enter the Override settings. See
the SCSI Override screen.
Caution: If this configuration setting is incorrectly set, processing difficulties
may occur. Before changing this setting, evaluate the need for the change and
verify the desired setting. HP recommends backing up the router configuration
to an external file before making changes to this setting.
Visual Manager User Interface
Appendix C, "Addressing
Figure 49 for an illustration of
77