Axle - Vermont Castings vc75 Assembly Procedures

VC50/75A ASSEMBLY
Step 4: Assemble casters, wheels and upper door support
Required: (2) Caster Inserts, (2) Casters, (2) Wheels, Axle, (2) Axle Caps, Upper Door Support, (2) 1/2" self
tap screws.
Place a caster insert into the bottom of each left leg, and lightly tap into place with a hammer. Snap the
casters into the inserts (Fig 4A).
Tap an axle cap onto 1 end of the axle. Slide a wheel onto the axle flush against the cap. Insert the end of the
axle down through the large holes at the bottom of the right legs. Lift the bottom of the legs up enough to
place the other wheel onto the axle (Fig 4B).
Install the upper door support to the front corners of the grill base with 2 self-tapping screws (Fig 4C).
Carefully lift the grill assembly off its back onto the wheels and casters (2 people). Tap the other axle cap
onto the axle.
Fig. 4A
Self Tap Screw
Caster
Self Tap
Screw
Fig. 4C
Page 4

Axle

Wheel
Cap
Fig. 4B