Vermont Castings vc75 Assembly Procedures page 2

VC50/75A ASSEMBLY
Step 2: Assemble Legs
Required: The Main Grill Unit, (2) Right Legs,
(2) Left Legs, (8) 1/4" x 1-3/4" Hex Head Bolts.
Carefully remove the grill unit from the carton bottom,
and lay it on its back (use the flattened carton cap as a
protective surface). This is best performed with 2
people (use of gloves is recommended). Ensure the
front lid does not fall open while moving the unit.
Allow the lid to rest partially open once the unit is on
its back.
Remove and discard the 2 shipping brackets and bolts
from the bottom of the unit by removing the 4 bolts
holding them to the base. Also remove and discard the
4 bolts above these (fig 2A).Attach the two right legs
(with the large hole at the bottom end) to the right side
of the base using (4) 1/4" x 1-3/4" bolts. Ensure that the
sides with the 2 small holes, about 6 inches from each
end, are facing inwards. Tighten the bolts only finger tight
(Fig 2B). Repeat for the left legs.
Fig. 2A
Fig. 2B
Page 2