Electromagnetic Compatibility; Fcc Part 15 Class B Device; En55022 - Emissions; En55024 - Electromagnetic Susceptibility - Hengstler XPM 80 Operating Manual

XPM 80™ Thermal Printer Family

13.1. Electromagnetic Compatibility

13.1.1. FCC Part 15 Class B Device

NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:




13.1.2. EN55022 – Emissions
The XPM 80™ family of thermal printers are class "B" appliances.

When operating the printer from a DC building power supply, or when the DC power
cable exceeds 3 meters in length, appropriate EMI filters must be used.
13.1.3. EN55024 – Electromagnetic Susceptibility
 Electrostatic discharges and burst effects may cause short printing interruptions, but
the automatic recovery function of the printer will restore it to its original state.
Additional action regarding lightning and overvoltage protection will be needed if
cables and wires are installed outside of a building.
However, this standard can be met only if original units, components, and cables are
used and the installation instructions are respected and followed completely.

External interference caused by ESD or EMI can temporarily cause corrupted printing
or data loss.

13.2. Printer Drawings

Please refer to the appropriate drawing listed in section 1.1 of this document for dimensions
and mounting information.
Part No. D 690 019
This equipment generates, uses and can radiate radio
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Mod. No. 4 051015 Eli1
HENGSTLER
However, there is no
page 32 of 32