Hengstler XPM 80 Operating Manual page 20

XPM 80™ Thermal Printer Family
Serial Pinout
DB-9 Female
Note: Pins 4 and 6 of the DB-9 connector must be jumpered to each other.
USB
The USB versions of the XPM 80™ printer employ a standard USB interface cable (5
pin Mini-B connector on the printer end) to communicate from the host to the printer.
Be sure that the Mini-B connector is fully engaged with the mating connector on the
printer. The other end of the cable plugs into the USB port on the host. The cable
length must be limited to under 3 meters.
Once the printer is connected with the host and the driver is installed, be sure to set
the Port in the driver to the appropriate USB port to match the physical host-side
interface cable port.
USB Pinout
Number
Part No. D 690 019
RJ-12
Pin No. Pin No.
2 ....................... 1
3 ....................... 2
7 ....................... 3
8 ....................... 4
5
5 ....................... 6
1
4
6
9
Pin
Signal name I/O Function
1 NC
2 D- I/O
3 D+ I/O
4 NC
5 SGND
Mod. No. 4 051015 Eli1
HENGSTLER
I/O Function (printer view)
TXD (transmit data)
RXD (receive data)
RTS (request to send)
CTS (clear to send)
no connection
System ground
no connection
DTR (data terminal ready)
DST (data set ready)
no connection
no connection
Data -
Data +
no connection
I/O Signal Ground
page 20 of 32