Electromagnetic Compatibility; Fcc Part 15 Class B Device - Hengstler eXtendo X-56 Operating Manual

®
eXtendo Thermal Printer Family
12 VDC
10-36 VDC
Cutter:
Presenter (optional):
Dimensions (WxHxD):
Temperature Range
Operating:
Storage:

13.3. Electromagnetic Compatibility

13.3.1. FCC Part 15 Class B Device

NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
•
•
•
Part No. D 684 124
With Hengstler paper, at 21° C ambient temperature, with a
print speed of 100 mm/sec, voltage of 24.0 VDC, and print
density (coverage) of 50%: 4.0 A avg.
With Hengstler paper, at 21° C ambient temperature, with a
print speed of 100 mm/sec, voltage of 12.0 VDC, and print
density (coverage) of 12.5%: 1.3 A avg.
With Hengstler paper, at 21° C ambient temperature, with a
print speed of 100 mm/sec, voltage of 12.0 VDC, and print
density (coverage) of 25%: 2.1 A avg.
With Hengstler paper, at 21° C ambient temperature, with a
print speed of 100 mm/sec, voltage of 12.0 VDC, and print
density (coverage) of 50%: 3.7 A avg.
With Hengstler paper, at 21° C ambient temperature, with a
print speed of 100 mm/sec, voltage of 12.0 VDC, and print
density (coverage) of 12.5%: 1.3 A avg.
With Hengstler paper, at 21° C ambient temperature, with a
print speed of 100 mm/sec, voltage of 12.0 VDC, and print
density (coverage) of 25%: 2.1 A avg.
With Hengstler paper, at 21° C ambient temperature, with a
print speed of 100 mm/sec, voltage of 12.0 VDC, and print
density (coverage) of 50%: 3.7 A avg.
Guillotine (full or partial cut) or Rotary Type (heavy stock)
Loop-type
125 x 100 x 100 mm (approx.)
-25 to +70ºC 20% to 100% RH, or
0 to +50ºC 25% to 80% RH, non-condensing
-30ºC to +75ºC
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Mod. No. 4 080812 LEV
HENGSTLER
page 37 of 38