Operation Of Controls, Sensors And Leds; Dual-Feed Controls; Dual-Feed Paper Guides - Hengstler XPM 80 Operating Manual

XPM 80™ Thermal Printer Family

3.5. Operation of Controls, Sensors and LEDs

3.5.1. Dual-Feed Controls

Two pushbuttons are mounted on the Dual-Feed unit and control its operation.
(Please note that these pushbuttons can be disabled through the XPM Configuration
Tool to prevent manual intervention with the paper path selection process.) Once
paper is loaded in both paper paths, the controls have the following functions.




3.5.2. Dual-Feed Paper Guides

There are two paper guides (one left and one right) for each of the two paper paths in
the DFU. These should be adjusted to properly guide the paper into the DFU. It is
important that the paper be centered in the paper path inlet to ensure the most
reliable, jam-free operation.
To adjust the paper guides, loosen the single screw in each until the guide will slide,
position it in its desired location, and tighten the screw.
Part No. D 690 019
Press and release control for selected path: Paper is placed in DFU park
position. (Neither paper path is selected; printer reports out of paper.)
Press and release control for unselected path: Paper for that path is
loaded into printer. Printer reports "ready to print".
Press and hold control for selected or unselected path: Paper for that
path will eject from back of DFU. Paper will have to be fully removed to clear
paper sensor and then reinserted before it can print. Printer will report out of
paper if that path was the selected paper path.
Mod. No. 4 051015 Eli1
HENGSTLER
Figure 5
page 13 of 32