Sokkia CX-101 Service Manual page 75

• You can edit the coordinate data
that was read in. Editing does
not affect the original coordinate
data. After editing, the point
name is no longer displayed.

• The point name that was read in is displayed until the current JOB is changed.
• When [SRCH] is pressed, CX searches data in the current JOB first, then in the
Coordinate Search JOB.
• If more than two points with the same point name exist in the current JOB, CX
finds the newer data only.
PROCEDURE Coordinate Data Search (Complete match)
1. Press [Search] on the registered
coordinate data list screen.
2. Enter search criteria.
Enter following items.
(1) Coordinate point name
(2) Search condition (complete
match)
(3) Search direction
3. Press [OK] to display the details
of searched data.

Searching the coordinate point name
Data is saved according to the time it was recorded. When there is more
than one coordinate point name matching the search, "the point nearest to
the currently selected data" is selected. See the Note below for search
method options.

Options for the setting items are as follows. (* is the setting when the power is
turned to ON.)
* Search method:  (searches backward from the current point name) */
 (searches forward from the current point name)
13. SETTING INSTRUMENT STATION
P T
C r i t e r i a : C o m p l e t e
D i r e c t . :
1 0 0
OK
65