Sokkia CX-101 Service Manual page 271

[OFFSET] : Offset measurement
[TOPO] : To TOPO menu
[EDM] : Setting EDM
[H-SET] : Set required horizontal angle
[TILT] : Display tilt angle
[MENU] : To Menu mode (Coordinates measurement, setting-out
[REM] : REM measurement
[RESEC] : Resection measurement (The instrument station coordinate
[R/L] : Select horizontal angle right/left
[ZA / %] : Switch between zenith angle/slope in %
[HOLD] : Hold horizontal angle/release horizontal angle
[CALL] : Display final measurement data
[S-LEV] : Return signal
[AREA] : Surface area measurement
[F/M] : Switch between meters/feet
[HT] : Set the instrument station height and target height
[S-O LINE] : Setting-out line measurement
[S-O ARC] : Setting-out arc measurement
[P-PROJ] : Point projection measurement
[PTL] : PT to Line
[INTSCT] : Intersections measurement
[TRAV] : Traverse adjustment
[ROAD] : Route surveying
[X SECT] : Cross section survey
[TOPOII] : Topography observation
[L-PLUM] : Brightness configuration for laser plummet
[HVDOUT-T] / [HVDOUT-S]
: Output distance/angle measurement results to an external
[HVOUT-T] / [HVOUT-S]
: Output angle measurement results to an external instrument
[NEZOUT-T] / [NEZOUT-S]
: Output the coordinate results to an external instrument
[---] : No functions set
Softkey Allocation Examples

It is possible to allocate the same key to each page (example 1). The same
function can be allocated to more than one key on the same page (example 2).
And it is also possible to allocate a function to only one key (example 3).
measurement, offset measurement, repetition measurement,
missing line measurement, REM measurement, resection
measurement, surface area measurement, set-out line, set-out
arc, point projection, intersections, traverse)
can be recorded on the measurement result screen.)
instrument
33. CHANGING THE SETTINGS
261