Mitsubishi Electric AG-150A Instruction Book page 35

Function
3 Set Temperature Set the temperature by
using the Up/Down arrows
below "Set Temp."
4 Fan mode Select the desired
operation mode from one
of the icons below "Mode".
5 Prohibiting local Press the button that
remote controller corresponds to each of the
operation following buttons to permit
or prohibit access to these
functions:
ON/OFF, operation mode,
and temperature.
6 Schedule Select the Available/Not
Available/Not Available status for the
Available schedule settings.
7 OK Press the OK button to
reflect the change.
8 Cancel Press the Cancel button to
cancel the change.
Operation method
Pressing the Up/Down arrow increases/decreases the temperature by one degree
respectively.
The settable temperature range depends on the mode and model. If the Up arrow
is touched when the upper limit temperature is displayed. The lower limit
temperature will appear, and the Down arrow vice versa.
Heating:
Heating ECO:
Hot Water:
Anti-freeze:
* Temperatures are displayed Fahrenheit if Fahrenheit is selected.
An orange frame will appear around the selected mode.
A function to prevent an accumulation of snow on top of the fan guard during winter
by forcing the fan to operate even while the unit is stopped
Pressing of each button toggles through the following three options:
Retention of current status  Permit  Prohibit
The Available/Not Available status changes with each pressing of the button.
Pressing the OK button saves the setting and takes the screen back to the previous
screen (Floor layout or Block display).
Pressing the Cancel button cancels the change and takes the screen back to the
previous screen (Floor layout or Block display).
25 ~ 70°C/77 ~ 158°F
Invalid
25 ~ 70°C/77 ~ 158°F
Invalid
Retention of
current status
ON/OFF
Operation mode
Temperature
setting
– 34 –
Display
Permit Prohibit