Mitsubishi Electric AG-150A Instruction Book page 87

8-1-4 Setting the PI controller (PAC-YG60MCA) settings
Main menu
Sub menu
Unit address
MC type selection
(1) Enter Meter
Name button
(1) Entering the meter name
Press the [Enter Meter Name] button to call up an on-screen keypad, and enter the meter name in 20 characters or less (regardless of
whether single-byte or two-byte characters are used).
* The following symbols cannot be used for the meter name: <, >, &, ", and '.
(2) Setting the pulse unit
Pressing the [Pulse Unit•Numeric Value] button will call up the on-screen numeric keypad (see 8-1-3(2)). Enter the desired values on the
keypad. The settable range is between 0.01 and 100.00 or the cell may be left blank (channels not used). The default value is blank.
Note: Be sure to set Pulse unit•Numeric value. Otherwise, Pulse Unit•Numeric Value or Pulse Unit•Measurement Unit will not be saved.
(3) Setting the measurement unit
Each pressing of the [Pulse Unit•Measurement Unit] button next to "Pulse unit" will toggle through [kWh]→[m
[--]→[](blank)→[kWh]. Select the unit that matches the value to be measured. The default value is [](blank). Leave the cells next to the
meters that will not be used to [](blank).
(4) Saving the settings
Touching the [Save Settings] button will save the changed settings.
– 86 –
(2) Pulse Unit•
Numeric Value button
(3) Pulse Unit•
Measurement Unit
button
(4) Save Settings button
3
]→[MJ]→