Supermicro SUPERSERVER 8048B-TR3 User Manual page 84

SUPERSERVER 8048B-TR3F/C0R3FT User's Manual
2
I C Bus to PCI-Exp. Slots
Use Jumpers JI
connect the System Management
Bus (I C) to the PCI-Express slots to
2
improve PCI performance. These two
jumpers are to be set at the same time.
The default setting is off to disable
the connection for normal operations.
See the table on the right for jumper
settings.
TPM Support Enable
JPT1 allows the user to enable TPM
(Trusted Platform Modules) support
to enhance data integrity and system
security. See the table on the right for
jumper settings. The default setting is
enabled.
Manufacturer Mode Select
Close pin 2 and pin 3 of Jumper
JPME2 to bypass SPI fl ash security
and force the system to operate in the
Manufacturer mode, which will allow
the user to fl ash the system fi rmware
from a host server for system setting
modifi cations. See the table on the
right for jumper settings.
SAS Enable (for X10QBL-CT only)
Use Jumper JPS1 to enable or disable
onboard SAS connections (L-SAS 0-3,
4-7) on the X10QBL-CT. The default
setting is on pins 1/2 to enable SAS
support. See the table on the right for
jumper settings.
C1 and JI C2 to
2 2
5-28
2
I C for PCI-E slots
Jumper Settings
Jumper Setting Defi nition
Off Normal (Default)
On Enabled
TPM Enable
Jumper Settings
Jumper Setting Defi nition
Pin 1-2 Enabled (Default)
Pin 2-3 Disabled
ME Mode Select
Jumper Settings
Jumper Setting Defi nition
Pin 1-2 Normal (Default)
Pin 2-3 Manufacture Mode
SAS Enable
Jumper Settings
Jumper Setting Defi nition
Pin 1-2 Enabled (Default)
Pin 2-3 Disabled