Vacon NX User Manual page 130

vacon • 128
Default page in the operating menu (P6.6.2)
Here you can set the location (page) in the
the display automatically moves as the set
switched on to the keypad. See setting of Default page above.
Timeout time (P6.6.3)
The Timeout time setting defines the time after which the keypad display returns to the Default page
(P6.6.1) see above.
Move to the Edit menu by pressing the
the change with the
button left
.
READY
Timeout time
90 s
Default page
NOTE! If the
Contrast adjustment (P6.6.4)
In case the display is unclear you can adjust its contrast through the same procedure as that for the
timeout time setting (see above).
Backlight time (P6.6.5)
Giving a value for the
going out. You can select here any time between 1 and 65535 minutes or
setting procedure see Timeout time (P6.6.3).
7.3.6.7 Hardware settings
NOTE! The Hardware settings submenu
(S6.5.1)). Store the password in a safe place!
In the Hardware settings submenu
functions of the hardware in your frequency converter. The functions available in this menu are
acknowledge timeout and HMI retry.
HMI acknowledge timeout (P6.7.3)
This function allows the user to change the timeout of the HMI acknowledgement time in cases
where there is an additional delay in the RS-232 transmission due to use of modems for
communication over longer distances, for example.
NOTE! If the frequency converter has been connected to the PC with a normal cable, the default
values of parametres 6.7.3 and 6.7.4 (200 and 5) must not be changed.
If the frequency converter has been connected to the PC via a modem and there is delay in
transferring messages, the value of par. 6.7.3 must be set according to the delay as follows:
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
7
Operating menu
Timeout time
Menu button right
Enter button
. You can return to the previous step anytime by pushing the
READY
Timeout time
90 s.
Figure 79. Timeout time setting
Timeout time
value is 0 the
Backlight time
, you can determine how long the backlight stays on before
is protected with a password (see Chapter Password
(S6.7) under the
(in special applications only) to which
(see below) has expired or as the power is
. Set the timeout time you want and confirm
READY
Timeout time
60 s.
setting has no effect.
'Forever'
System menu you can further control some
CONTROL KEYPAD
Menu
CONFIRM CHANGE
enter
CANCEL
11393_uk
. For the value
HMI