Mitsubishi GOT2000 Series Connection Manual page 280


Setting Stage No. and Slot No.
POINT POINT POINT
Before setting Stage No. and Slot No.
The PLC CPU recognizes the GOT as follows.
• QCPU (Q mode)
: Intelligent function module of 16 I/O points
• Other than QCPU (Q mode)
: Intelligent function module of 32 I/O points
At the [Detail setting], assign the GOT to an empty I/O
slot on the PLC CPU.
(1) When connecting to QCPU (Q mode)
Set an additional stage (16 points
connection, and assign a GOT to one of the I/O slots.
(The GOT cannot be assigned to empty slots of the
main base unit or extension base unit.)
Main base unit
Q312B
Extension base unit
Q68B
Stage No. :2 Stage No.
Slot No. :0 Slot No.
POINT POINT POINT
When using the bus extension connector box
Set the Stage No. switch on the bus extension
connector box to the same Stage No. as the GOT.
For setting details, refer to the following manual:
A9GT-QCNB Bus Extension Connector Box
User's Manual
8 - 34
8. BUS CONNECTION
8.3 GOT Side Settings
10 slots) for GOT
Extension
stage 1
Stage No. setting
connector
:2 Stage No. :2
:1 Slot No. :2
POINT POINT POINT
When connecting to motion controller CPU (Q Series)
In the [Base Setting] on MT Developer, set "10" to the
number of slots for the extension base used for GOT
connection.
Example: When setting "2" to Stage No. and "0" to Slot
No. in the communication interface settings,
set "10" to [2nd Stage].