Obtaining Information On Usb Flash Devices - Cisco 1941W Configuration Manual

How to Use the ROM Monitor—Typical Tasks
enable "ignore system config info"? y/n [n]: y
change console baud rate? y/n [n]: y
enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400 [0]: 0
change the boot characteristics? y/n [n]: y
enter to boot:
0 = ROM Monitor
1 = the boot helper image
2-15 = boot system
[0]: 0
Configuration Summary
enabled are:
diagnostic mode
console baud: 9600
boot: the ROM Monitor
rommon 8>

Obtaining Information on USB Flash Devices

This section describes how to obtain information on USB devices that are installed in the router. For
instructions on booting from a USB flash device, see the
page
SUMMARY STEPS
1.
2.
DETAILED STEPS
Command or Action
Step 1 dir usbflash [x]:
Example:
rommon > dir usbflash0:
Step 2 dev
Example:
ROMMON > dev
Examples
Sample Output for the dir usbFlash Command
rommon > dir usbflash0:
program load complete, entry point: 0x80903000, size: 0x4c400
Directory of usbflash0:
2 54212244
Sample Output for the dev ROM Monitor Command
rommon 2 > dev
Devices in device table:
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
C-14
C-8.
dir usbflash [x]:
dev
-rw- c2900-universalk9-mz
"Loading a System Image (boot)" section on
Purpose
Displays the contents of the USB flash device, including
directories, files, permissions, and sizes.
0—USB flash device inserted in port 0
•
1—USB flash device inserted in port 1
•
Shows the targeted USB flash devices that are inserted in
the router and the valid device names that may or may not
be currently inserted.
Appendix C Using ROM Monitor