Cisco 1941W Configuration Manual page 83

Chapter Configuring Ethernet Virtual Connection Bridge Domain
Command
Step 11
ethernet cfm global
Example:
Router(config)# ethernet cfm global
Step 12
ethernet cfm ieee
Example:
Router(config)# ethernet cfm ieee
Step 13
ethernet cfm traceroute cache
Example:
Router(config)# ethernet cfm
traceroute cache
Step 14
ethernet cfm traceroute cache size
entries
Example:
Router(config)# ethernet cfm
traceroute cache size 200
Step 15
ethernet cfm traceroute cache
hold-time minutes
Example:
Router(config)# ethernet cfm
traceroute cache hold-time 60
Step 16
interface type number
Example:
Router(config)# interface ethernet
0/3
Step 17
ethernet cfm mep domain domain-name
mpid mpid {port| vlan vlan-id}
Example:
Router(config-if)# ethernet cfm mep
domain Customer mpid 701 vlan 100
Step 18
ethernet cfm mep domain domain-name
mpid mpid {port| vlan vlan-id}
Example:
Router(config-if)# ethernet cfm mep
domain Customer mpid 701 vlan 100
Step 19
end
Example:
Router(config-if)# end
Router#
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Connectivity Fault Management (CFM) over EVC BD
Purpose
Enables CFM processing globally on the device.
Enables the CFM IEEE version of CFM.
This command is automatically issued when the
•
ethernet cfm global command is issued.
Enables caching of CFM data learned through traceroute
messages.
Sets the maximum size for the CFM traceroute cache
table.
Sets the amount of time that CFM traceroute cache entries
are retained.
Specifies an interface and enters interface configuration
mode.
Sets a port as internal to a maintenance domain and
defines it as a MEP.
Sets a port as internal to a maintenance domain and
defines it as a MEP.
Returns the router to the privileged EXEC mode.
75