Configuring Radio Settings; Enabling The Radio Interface - Cisco 1941W Configuration Manual

Configuring Radio Settings

The following sections describe how to configure radio settings for the wireless device:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Enabling the Radio Interface

The wireless device radios are disabled by default.
You must create a service set identifier (SSID) before you can enable the radio interface.
Note
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Enabling the Radio Interface, page 261
Configuring the Role in the Radio Network, page 263
Configuring Dual-Radio Fallback, page 265
Configuring Radio Data Rates, page 266
Configuring MCS Rates, page 269
Configuring Radio Transmit Power, page 271
Configuring Radio Channel Settings, page 273
Enabling and Disabling World Mode, page 279
Disabling and Enabling Short Radio Preambles, page 281
Configuring Transmit and Receive Antennas, page 282
Enabling and Disabling Gratuitous Probe Response, page 283
Configuring the Ethernet Encapsulation Transformation Method, page 285
Enabling and Disabling Public Secure Packet Forwarding, page 286
Configuring the Beacon Period and the DTIM, page 288
Configure RTS Threshold and Retries, page 289
Configuring the Maximum Data Retries, page 290
Configuring the Fragmentation Threshold, page 290
Enabling Short Slot Time for 802.11g Radios, page 291
Performing a Carrier Busy Test, page 291
Configuring VoIP Packet Handling, page 292
261