Cisco 1941W Configuration Manual page 120

Configuring Dial Backup and Remote Management Through the Console Port or Auxiliary Port
Command
Step 11
ip route prefix mask {ip-address | interface-type
interface-number [ip-address]}
Example:
Router(config)# ip route 0.0.0.0 0.0.0.0 22.0.0.2
Router(config)#
Step 12
access-list access-list-number {deny | permit} source
[source-wildcard]
Example:
Router(config)# access-list 1 permit 192.168.0.0
0.0.255.255 any
Step 13
dialerwatch-list group-number {ip ip-address
address-mask | delay route-check initial seconds}
Example:
Router(config)# dialer watch-list 1 ip 22.0.0.2
255.255.255.255
Router(config)#
Step 14 line [aux | console | tty | vty] line-number
[ending-line-number]
Example:
Router(config)# line console 0
Router(config-line)#
Step 15
modem enable
Example:
Router(config-line)# modem enable
Router(config-line)#
Step 16 exit
Example:
Router(config-line)# exit
Router(config)#
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
112
Chapter Configuring Backup Data Lines and Remote Management
Purpose
Sets the IP route to point to the dialer
interface as a default gateway.
Defines an extended access list that
indicates which addresses need
translation.
Evaluates the status of the primary link,
based on the existence of routes to the
peer. The address 22.0.0.2 is the peer IP
address of the ISP.
Enters configuration mode for the line
interface.
Switches the port from console port to
auxiliary port function.
Exits interface configuration mode.
OL-20696-04