Cisco 1941W Configuration Manual page 328

Managing the System Time and Date
DETAILED STEPS
Command
Step 1 configure terminal
Step 2 clock summer-time zone date [month
date year hh:mm month date year hh:mm
[offset]]
or
clock summer-time zone date [date
month year hh:mm date month year
hh:mm [offset]]
Step 3 end
Step 4 show running-config
Step 5 copy running-config startup-config
The first part of the clock summer-time global configuration command specifies when summer time
begins, and the second part specifies when it ends. All times are relative to the local time zone. The start
time is relative to standard time. The end time is relative to summer time. If the starting month is after
the ending month, the system assumes that you are in the southern hemisphere.
To disable summer time, use the no clock summer-time command in global configuration mode.
This example shows how to set summer time to start on October 12, 2000, at 02:00, and end on April 26,
2001, at 02:00:
AP(config)# clock summer-time pdt date 12 October 2000 2:00 26 April 2001 2:00
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
320
Purpose
Enters global configuration mode.
Configures summer time to start on the first date and end on the second
date.
Summer time is disabled by default.
For zone, specify the name of the time zone (for example, PDT) to be
•
displayed when summer time is in effect.
(Optional) For week, specify the week of the month (1 to 5 or last).
•
(Optional) For day, specify the day of the week (for example,
•
Sunday).
(Optional) For month, specify the month (for example, January).
•
(Optional) For hh:mm, specify the time (24-hour format) in hours and
•
minutes.
(Optional) For offset, specify the number of minutes to add during
•
summer time. The default is 60.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Chapter Administering the Wireless Device