Configuring Wireless Lan Interfaces; Configuring Interface Card And Module Interfaces; Configuring A Loopback Interface - Cisco 1941W Configuration Manual

Chapter Basic Router Configuration
Command
Step 3
no shutdown
Example:
Router(config-if)# no shutdown
Router(config-if)#
Step 4 exit
Example:
Router(config-if)# exit
Router(config)#

Configuring Wireless LAN Interfaces

The wireless LAN interface on the Cisco 1941W router enables connection to the router through
interface wlan-ap0. For more information about configuring a wireless connection, see the
"Configuring the Wireless Device" section on page

Configuring Interface Card and Module Interfaces

To configure interface cards and modules inserted in internal services module (ISM), enhanced
high-speed WAN interface card (EHWIC), Ethernet WAN interface card (EWIC), and service module
(SM) slots, see the appropriate interface card or module configuration documents on Cisco.com.

Configuring a Loopback Interface

The loopback interface acts as a placeholder for the static IP address and provides default routing
information.
For complete information on the loopback commands, see the Cisco IOS Release configuration guide
documentation set.
To configure a loopback interface, follow these steps, beginning in global configuration mode.
SUMMARY STEPS
1.
2.
3.
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
interface type number
ip address ip-address mask
exit
Configuring Wireless LAN Interfaces
Purpose
Enables the GE interface, changing its state
from administratively down to administratively
up.
Exits configuration mode for the GE interface
and returns to global configuration mode.
247.
19