Obtaining Information On Usb Flash Devices - Cisco 2800 Series Manual

How to Use the ROM Monitor—Typical Tasks
[0]: 0
Configuration Summary
enabled are:
diagnostic mode
console baud: 9600
boot: the ROM Monitor
rommon 8>

Obtaining Information on USB Flash Devices

This section describes how to obtain information on USB devices that are installed in the router. For
instructions on booting from a USB flash device, see the
page
SUMMARY STEPS
1.
2.
DETAILED STEPS
Command or Action
Step 1
dir usbflash [x]:
Example:
rommon > dir usbflash1:
Step 2
dev
Example:
ROMMON > dev
Examples
Sample Output for the dir usbFlash Command
rommon >
Directory of usbflash0:
2
Sample Output for the dev ROM Monitor Command
rommon 2 > dev
Devices in device table:
id
flash: compact flash
bootflash: boot flash
usbflash0: usbflash0
Using the ROM Monitor
18
10.
dir usbflash [x]:
dev
dir usbflash0:
18978364 -rw-
name
Purpose
Displays the contents of the USB flash device, including
directories, files, permissions, and sizes.
• 0—USB flash device inserted in port 0
1—USB flash device inserted in port 1
•
Shows the targeted USB flash devices that are inserted in
the router and the valid device names that may or may not
be currently inserted.
c3845-entbasek9-mz.124-0.5
"Loading a System Image (boot)" section on
OL-5997-02