Monitoring The Wireless Device; Managing The System Time And Date - Cisco 1941W Configuration Manual

Chapter Administering the Wireless Device

Monitoring the Wireless Device

This section provides commands for monitoring hardware on the router.
•
•
Displaying Wireless Device Statistics
Use the service-module wlan-ap0 statistics command in privileged EXEC mode to display wireless
device statistics. The following is sample output for the command:
CLI reset count = 0
CLI reload count = 1
Registration request timeout reset count = 0
Error recovery timeout reset count = 0
Module registration count = 10
The last IOS initiated event was a cli reload at *04:27:32.041 UTC Fri Mar 8 2007
Displaying Wireless Device Status
Use the service-module wlan-ap0 status command in privileged EXEC mode to display the status of
the wireless device and its configuration information. The following is sample output for the command:
Service Module is Cisco wlan-ap0
Service Module supports session via TTY line 2
Service Module is in Steady state
Service Module reset on error is disabled
Getting status from the Service Module, please wait..
Image path = flash:c8xx_19xx_ap-k9w7-mx.acregr/c8xx_19xx_ap-k9w7-mx.acre
gr
System uptime = 0 days, 4 hours, 28 minutes, 5 seconds
Router#d was introduced for embedded wireless LAN access points on Integrated Services
Routers.

Managing the System Time and Date

You can manage the system time and date on the wireless device automatically, by using the Simple
Network Time Protocol (SNTP), or manually, by setting the time and date on the wireless device.
For complete syntax and usage information for the commands used in this section, see Cisco IOS
Note
Configuration Fundamentals Command Reference for Release 12.4.
This section provides the following configuration information:
•
•
•
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Displaying Wireless Device Statistics, page 315
Displaying Wireless Device Status, page 315
Understanding Simple Network Time Protocol, page 316
Configuring SNTP, page 316
Configuring Time and Date Manually, page 316
Managing the System Time and Date
315