Cisco 1941W Configuration Manual page 82

Connectivity Fault Management (CFM) over EVC BD
Command
Step 3
ethernet cfm domain domain-name level
level-id
Example:
Router(config)# ethernet cfm domain
Customer level 7
Step 4
service {ma-name | ma-num | vlan-id
vlan-id | vpn-id vpn-id} [port | vlan
vlan-id [direction down]]
Example:
Router(config-ecfm)# service
Customer1 vlan 101 direction down
Step 5
continuity-check [interval time |
loss-threshold threshold | static
rmep]
Example:
Router(config-ecfm-srv)#
continuity-check
Step 6
continuity-check [interval time |
loss-threshold threshold | static
rmep]
Example:
Router(config-ecfm-srv)#
continuity-check interval 10
Step 7
continuity-check [interval time |
loss-threshold threshold | static
rmep]
Example:
Router(config-ecfm-srv)#
continuity-check loss-threshold 10
Step 8
exit
Example:
Router(config-ecfm-srv)# exit
Step 9
mep archive-hold-time minutes
Example:
Router(config-ecfm)# mep
archive-hold-time 60
Step 10
exit
Example:
Router(config-ecfm)# exit
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
74
Chapter Configuring Ethernet Virtual Connection Bridge Domain
Purpose
Defines a CFM maintenance domain at a particular
maintenance level and enters Ethernet CFM configuration
mode.
Configures an MA within a maintenance domain and
enters CFM service configuration mode.
If a service is already configured and you configure a
•
new MA name and also specify the direction down
keyword, a second service is added that maps to the
same VLAN. If you configure a new MA name and
do not specify the direction down keyword, the
service is renamed to the new MA name.
Enables the transmission of CCMs.
Configures the time period between CCM transmissions.
The values supported are platform dependent.
•
Sets the number of CCMs that should be missed before
declaring that a remote MEP is down.
Returns the device to Ethernet CFM configuration mode.
Sets the amount of time that data from a missing MEP is
kept in the continuity check database or that entries are
held in the error database before they are purged.
Returns the device to global configuration mode.