Cisco 1941W Configuration Manual page 152

Configuring VPN
DETAILED STEPS
Command or Action
Step 1 crypto ipsec client ezvpn name
Example:
Router(config)# crypto ipsec client ezvpn
ezvpnclient
Router(config-crypto-ezvpn)#
Step 2
group group-name key group-key
Example:
Router(config-crypto-ezvpn)# group
ezvpnclient key secret-password
Router(config-crypto-ezvpn)#
Step 3
peer {ipaddress | hostname}
Example:
Router(config-crypto-ezvpn)# peer
192.168.100.1
Router(config-crypto-ezvpn)#
Step 4
mode {client | network-extension | network
extension plus}
Example:
Router(config-crypto-ezvpn)# mode client
Router(config-crypto-ezvpn)#
Step 5
exit
Example:
Router(config-crypto-ezvpn)# exit
Router(config)#
Step 6 crypto isakmp keepalive seconds
Example:
Router(config-crypto-ezvpn)# crypto isakmp
keepalive 10
Router(config)#
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
144
Chapter Configuring Security Features
Purpose
Creates a Cisco Easy VPN remote configuration,
and enters Cisco Easy VPN remote configuration
mode.
Specifies the IPSec group and IPSec key value for
the VPN connection.
Specifies the peer IP address or hostname for the
VPN connection.
A hostname can be specified only when
Note
the router has a DNS server available for
hostname resolution.
Use this command to configure multiple
Note
peers for use as backup. If one peer goes
down, the Easy VPN tunnel is established
with the second available peer. When the
primary peer comes up again, the tunnel is
reestablished with the primary peer.
Specifies the VPN mode of operation.
Returns to global configuration mode.
Enables dead peer detection messages. Time
between messages is given in seconds, with a
range of 10 to 3600.