Install The Device; Rack Compatibility - Cisco Network Convergence System 540 Hardware Installation Manual

Install the Device

Before you begin this task, ensure that you have read and understood the safety warnings in the Standard
Warning Statements section of the Safety Warnings handout.
Installing the Cisco N540-24Q8L2DD-SYS involves these tasks:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Rack Compatibility

We recommend that you follow these rack specifications.
Rack Compatibility, on page 29
Set up Device on Rack, on page 32
Ground the Device, on page 37
Install the AC Power Cables, on page 38
Install the DC Power Cables, on page 40
Port Connection Guidelines , on page 41
Connect to the Console Port , on page 42
Connect to the Management Ethernet Port, on page 44
Connecting Timing Cables, on page 45
Connecting a Cable to the GNSS Antenna Interface, on page 46
Install and Remove Transceiver Module, on page 47
Install and Remove QSFP+, QSFP28, or QSFP-DD Transceiver Modules, on page 51
Removing the 40-Gigabit QSFP+, 100-Gigabit QSFP28, or 200/400-Gigabit QSFP-DD Transceiver
Module, on page 56
Connect Interface Ports, on page 57
Maintain Transceivers and Optical Cables, on page 58
Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide
4
C H A P T E R
29