Configuring Wireless Settings; Configuring Wireless Radio Settings - Cisco RV315W Administration Manual

Port Management

Configuring Wireless Settings

Configuring Wireless Settings
STEP 1
STEP 2
Cisco RV315W Broadband Wireless VPN Router Administration Guide
click Delete, enter the VLAN ID in the VLAN ID field, and then click OK. The
reserved VLAN1 and VLAN2 cannot be deleted.
The wireless module of the RV315W is enabled by default. To connect to the
default wireless network of the RV315W for the first time, use the default wireless
network name (SSID) and pre-shared key that are provided on the product label at
the bottom of the RV315W.

Configuring Wireless Radio Settings

To configure the wireless radio settings:
Click Port Settings > WLAN Settings. The WLAN Settings page opens.
In the WLAN Radio Settings area, enter the following information:
• Radio: Check Enable to turn the wireless radio on, or check Disable to turn
the wireless radio off. The wireless radio is turned on by default.
• Wireless Network Mode: Choose one of the following options:
- 802.11b/g/n Mixed: Choose this option if you have Wireless-N,
Wireless-B, and Wireless-G devices in your network. This is the default
setting (recommended).
- 802.11b/g Mixed: Choose this option if you have Wireless-B and
Wireless-G devices in your network.
- 802.11b: Choose this option if you have only Wireless-B devices in your
network.
- 802.11g: Choose this option if you have only Wireless-G devices in your
network.
- 802.11n: Choose this option if you have only Wireless-N devices in your
network.
• Wireless Band Selection: Select the wireless bandwidth on your network
(20 MHz, 40 MHz, or Auto).
4
43