Settings; Information List; Settings Groups; Description - Siemens SIPROTEC 7RW80 Manual

Functions
2.1 General

2.1.4.3 Settings

Addr. Parameter
401 WAVEFORMTRIGGE
R
402 WAVEFORM DATA
403 MAX. LENGTH
404 PRE. TRIG. TIME
405 POST REC. TIME
406 BinIn CAPT.TIME

2.1.4.4 Information List

No. Information
- FltRecSta
4 >Trig.Wave.Cap.
203 Wave. deleted
30053 Fault rec. run.
2.1.5

Settings Groups

Up to four different setting groups can be created for establishing the device's function settings.

2.1.5.1 Description

Changing Setting Groups
During operation the user can switch back and forth setting groups locally, via the operator panel, binary inputs
(if so configured), the service interface using a personal computer, or via the system interface. For reasons of
safety it is not possible to change between setting groups during a power system fault.
A setting group includes the setting values for all functions that have been selected as Enabled during con-
figuration (see Section 2.1.1.2). In 7RW80 relays, four independent setting groups (A to D) are available. While
setting values may vary, the selected functions of each setting group remain the same.
36
Setting Options
Save w. Pickup
Save w. TRIP
Start w. TRIP
Fault event
Pow.Sys.Flt.
0.30 .. 5.00 sec
0.05 .. 0.50 sec
0.05 .. 0.50 sec
0.10 .. 5.00 sec; ∞
Type of In-
formation
IntSP Fault Recording Start
SP >Trigger Waveform Capture
OUT_Ev Waveform data deleted
OUT Fault recording is running
Default Setting
Save w. Pickup Waveform Capture
Fault event Scope of Waveform Data
2.00 sec Max. length of a Waveform
Capture Record
0.10 sec Captured Waveform Prior to
Trigger
0.10 sec Captured Waveform after Event
0.50 sec Capture Time via Binary Input
Comments
C53000-G1140-C233-1, Release date 10.2010
Comments
SIPROTEC, 7RW80, Manual