Setting Notes; Settings; Information List - Siemens SIPROTEC 7RW80 Manual

Functions
2.1 General

2.1.2.2 Setting Notes

Fault Display
A new pickup by a protection element generally turns off any previously lit LEDs so that only the latest fault is
displayed at any one time. It can be selected whether the stored LED displays and the spontaneous fault indi-
cations on the display appear upon the new pickup, or only after a new trip signal is issued. In order to select
the desired displaying mode, select the submenu Device in the SETTINGS menu. Under address 610
FltDisp.LED/LCD the two alternatives Target on PU and Target on TRIP ("No trip – no flag") can be
selected.
Use parameter 611 Spont. FltDisp. to specify whether or not a spontaneous fault message should appear
automatically on the display (YES) or not (NO).
Selection of Default Display
The start page of the default display appearing after startup of the device can be selected in the device data
via parameter 640 Start image DD. The pages available for each device version are listed in the Appendix
A.4.

2.1.2.3 Settings

Addr. Parameter
610 FltDisp.LED/LCD
611 Spont. FltDisp.
640 Start image DD

2.1.2.4 Information List

No. Information
- >Light on
- Reset LED
- DataStop
- Test mode
- Feeder gnd
- Brk OPENED
- HWTestMod
- SynchClock
- Distur.CFC
1 Not configured
2 Non Existent
3 >Time Synch
5 >Reset LED
28
Setting Options
Target on PU
Target on TRIP
YES
NO
image 1
image 2
image 3
image 4
Type of In-
formation
SP >Back Light on
IntSP Reset LED
IntSP Stop data transmission
IntSP Test mode
IntSP Feeder GROUNDED
IntSP Breaker OPENED
IntSP Hardware Test Mode
IntSP_Ev Clock Synchronization
OUT Disturbance CFC
SP No Function configured
SP Function Not Available
SP_Ev >Synchronize Internal Real Time Clock
SP >Reset LED
Default Setting
Target on PU Fault Display on LED / LCD
NO Spontaneous display of flt.annun-
ciations
image 1 Start image Default Display
Comments
C53000-G1140-C233-1, Release date 10.2010
Comments
SIPROTEC, 7RW80, Manual