Switching Times Of Time Switch Program 3 (D.h.w.) - Siemens RVA63.242 User Manual

Description
Setting
• • •
Important
Note
Effect
Program overview
54/218
Siemens Building Technologies
Landis & Staefa Division
3.15 Switching times of time switch program 3
(d.h.w.)
This is the setting of the switching times for d.h.w. time switch program at which the
d.h.w. temperature setpoint will change.
The time switch program thus set is activated by pressing the d.h.w. operating mode
button .
Setting range
- -:- -...24:00
First, select the weekday for which the switching times shall be entered!
The controller then makes a check to ensure the entries have been made in the correct
order.
At the times entered, the program will switch to the respective temperature setpoints.
The table below shows at what times the setpoints will be activated.
Entry:
– – : – – Switching point inactive.
00:00...24:00At the time entered, heating to the respective temperature is ensured.
Line Switching point
Switch-on time period 1
Switch-off time period 1
Switch-on time period 2
Switch-off time period 2
Switch-on time period 3
Switch-off time period 3
Basic Documentation RVA63.242, RVA53.242
Description of end-user settings
Unit
h : min
D.h.w temperature setpoint
Nominal setpoint
Reduced setpoint
Nominal setpoint
Reduced setpoint
Nominal setpoint
Reduced setpoint
Factory setting
See "Program overview"
below
Standard
06:00
22:00
– – : – –
– – : – –
– – : – –
– – : – –
CE1P2373E
26.03.2001