Service; Continuous Display; Software Version; Device Operating Hours - Siemens RVA63.242 User Manual

Benefit
Setting
Effect
Note
Benefit
Description
Setting
Effect
Benefit
Description
Setting
Effect
Siemens Building Technologies
Landis & Staefa Division

Service

5.40 Continuous display

Choice of continuous displays.
Setting range
0 / 1
The setting will change the continuous display which appears when no setting line is
selected.
With heat generation functionality
0 Weekday / time of day
1 Actual value of the boiler
temperature
In the case of application 2 x 1 cascade or cascade slave, it is always the boiler
temperature that is displayed.

5.41 Software version

Straightforward display of software version in use, without removing the controller
The software version installed represents the state of the software available at the time
the controller was produced.
Display
00.0 ... 99.9
The software version will automatically be displayed on this line.
Example: 01.0
The first 2 digits give the software version
The third digit gives the software revision

5.42 Device operating hours

Display of the number of device operating hours.
Here, you can read the number of hours the controller has been in operation
Display
0... 500'000
The number of operating hours since the controller was first commissioned will
automatically be displayed on this line.
The hours considered as operating hours are those during which power was supplied to
the controller, that is, including the periods of time with no effective heating operation.
The number of operating hours cannot be reset.
Basic Documentation RVA63.242, RVA53.242
Description of OEM settings
Unit
–
Without heat generation functionality
Weekday / time of day
Actual value of the flow temperature
heating circuit
Unit
Digits
(01.)
(.0)
Unit
h
Factory setting
0
185/218
CE1P2373E
26.03.2001