Bracket Installation - Optex HX-40 Installation Instructions Manual

Fasten the base to the wall.
3
6
BRACKET INSTALLATION AND ADJUSTMENT
Using the bracket makes it possible to adjust the unit through 180° degree.
In cases where the ground is uneven and therefore not parallel with the base of the unit, it is
possible to adjust the unit vertically by ± 20 degree (see section 6-B)
90°
6-A

Bracket installation

Remove the up-down lock screw.
1
Push the shaft cover clip outwards to
2
remove the shaft cover.
Shaft cover
90°
Press with suitable tool.
e.g. small screwdriver
-4-
Put the main unit and lens.
4
Caution>>
Do not change the detection
distance with bracket.
Use the masking seal to
adjust the detection distance.
20°
20°
Loosen the adjustment screw two turns.
3
Adjustment screw
Caution>>
Do not loosen the
screw too much.
The screw separates
from the unit.
Tilt the bracket about 45° and pass
4
through the wire.
In
Out