Positioner Area - Panasonic AV-HS410N Operating Instructions Manual

1. Parts and their functions

1-1-6. Positioner area

 Positioner (POSITIONER) [X/Y]
These are used when performing the settings below.
 PinP1, PinP2 position settings
 Wipe start position setting
Target patterns:
WIPE1: 5
WIPE2: 4, 5, 6, 7
SQ1: 5
SQ2: 4, 5, 6, 7
 Refer to "1‑2. Wipe" (<Operations and Settings>
Operating Instructions).
 Flying key position setting
 Chroma key marker position setting
In each case, the settings take effect only when the
following menu items have been selected.
Note
During the time it takes for the unit to start up after its
power is turned on, the unit detects the positions of the
positioners and sets them to their center positions.
Do not touch the positioners until the unit has started up.
Positioner
PinP1, PinP2
Position adjustments
WIPE (BKGD)
Start position
adjustments
WIPE (KEY) Start position
adjustments
Chroma key Selection position
adjustments
Flying key
Position adjustments
X/Y
Size adjustments
(size increased by rotating the
encoder clockwise and reduced
by rotating it counterclockwise)
—
—
Selected area size adjustments
(size increased by rotating the
encoder clockwise and reduced
by rotating it counterclockwise)
Size adjustments
(size increased by rotating the
encoder clockwise and reduced
by rotating it counterclockwise)

Z

X/Y
POSITIONER
 Rotary encoder [Z]
This is used to set the PinP size, flying key size or to select
the chroma key area.
In each case, the settings take effect only when the
following menu items have been selected.
Rotary encoder
Z
Hold switch down to restore
initial values (X/Y, Z).
Hold switch down to restore
initial values (X/Y).
Hold switch down to restore
initial values (X/Y).
Execute sampling
Hold switch down to restore
size to initial values.
Hold switch down to restore
initial values (X/Y, Z).
25
Valid menu
Switch
All PinP1 and PinP2 menus
Background/WIPE Position
Background/SQ Position
Key/WIPE Position
Key/SQ Position
Chroma Key
Key: Flying Key