Table of Contents
Advertisement
Threading the upper thread
1
2
3
4
5
6
7
1) Turn the handwheel towards you (counterclockwise) to bring the needle to highest position. Raise the
presser foot lifter
2) Place the thread and spool holder (1) onto the spool pin. For better sewing quality, choose a proper size
of the spool holder for the thread and attach it next to the spool.
3) Draw the thread from the spool and place the thread in between the thread guide. Guide the thread
ahead and pull the thread through the pre-tension spring as illustrated.
4) Continue to guide the thread into the silver discs to keep the thread in proper tension. Pass the thread
under the take-up spring then pull it upwards as arrow marks illustrated.
5) Pull the thread to the top then pass the thread through the slotted eye of the take-up lever. Guide it down
afterwards. Pass the thread behind the flat, horizontal thread guide. Pull the end of it through the needle
from front to rear and pull out about 10 cm of thread.
6) Hold the upper thread with your left hand. Turn the handwheel counter-clockwise to lower the needle
down below the needle plate then raise it to bring the bobbin thread up.
7) Pull both threads to the back under the presser foot.
11
Advertisement
Table of Contents
