Monogram ZGP304L Owner's Manual page 34

Dual-flame
base, burner head, and burner cap. The burner
stacked
head and burner cap can be lifted off, making
burners
them easy to clean.
BURNER WITHOUT ALL BURNER PARTS IN PLACE.
Surface burners should be cleaned routinely,
especially after bad spillovers, which could clog
the slots and holes in the burner heads.
The electrode is located at the rear of each
burner. Do not attempt to disassemble or clean
around any burner while another burner is on. An
electric shock may result.
burners. Be sure to replace the burners in the
same location.
34
DO NOT OPERATE THE
Electrode
Turn all controls before removing any
burner parts.
When cool, you may lift off the burner grates,
burner caps and burner heads for easier
cleaning.
The ZGP304 model has 2 different size
Care and Cleaning
Cleaning
Lift off burner parts only when cool. Wash in hot,
soapy water. You may use a plastic scouring pad
to remove burned-on food particles.
heads in a solution of mild liquid detergent and
hot water for 20–30 minutes. For more stubborn
stains, use a plastic scouring pad or toothbrush.
If the spill goes inside the burner head assembly,
wash it under running water and shake to
remove excess water.
Burner Cap
Make sure that the burner parts are replaced in
the correct location.
1. Replace the burner head on top of the burner
base, making sure that the hole in the burner
Burner
Head
head is properly aligned with the electrode
in the burner base. A small gap between the
base and head is normal.
2. Place the burner cap on top of the burner
Burner Base
head. Make sure that the burner cap is
properly seated on the burner head.
Professional All-Gas Range
soak the burner
Burner cap properly seated
Burner cap not properly seated