Yeastar Technology TA810 User Manual page 8

route dial rules.

Calls from PSTN to SIP
1) Create an inbound route on your SIP server, and select the SIP trunk you
have registered just now.
2) Configure a "Port->IP" route on TA410/810, choose a PSTN trunk or PSTN
trunk group in the field "Call Source", and choose the SIP account in the filed
"Call Destination".
3) When a call comes to PSTN trunk on TA410/810, the call will be routed to the
destination of the SIP server inbound route.

Register SIP account on IP phone
With account mode, you can directly take the SIP account to register on your SIP
phone or softphone; then make calls from softphone though PSTN trunk on
TA410/810 and receive incoming calls on your SIP phone or softphone. In this
way, you don't have to set up any SIP server.
VoIP Mode
Take a SIP account from your SIP server, and register it on TA410/810 as a VoIP trunk.
In this way, TA410/810 and your SIP server are connected.

Calls from SIP to PSTN
1) Configure a IP-> Port route on TA410/810; choose the VoIP trunk in the field
"Call Source", and choose PSTN trunk in the field "Call Destination".
Two-stage Dialing
2) Make a call from your SIP server, dial the SIP account number which is
registered on TA410/810. You will hear a dial tone, then dial the external
number out through PSTN trunk.

Calls from PSTN to SIP
1) Configure a Port->IP route on TA410/TA810, choose PSTN trunk in the field
"Call Source", and choose the SIP trunk in the field "Call Destination".
2) When an incoming call reaches PSTN trunk on TA410/810, you will hear a
dial tone, then dial an extension number of the SIP server.
SPS Mode (Recommended)
Create a Service Provider SIP trunk on TA410/810 to connect to your SIP server. Add
another Service Provider SIP trunk on your SIP server, connecting to TA410/810.

Calls from SIP to PSTN
1) Create one outbound route on your SIP sever, and select the SIP trunk you
have created just now.
2) Configure a IP->Port route on TA410/810, choose the SPS trunk in the field
"Call Source", and choose PSTN trunk in the field "Call Destination".
3) Make a call from your SIP Server and the call should match the outbound
route dial rules.

Calls from PSTN to SIP
on the route.
TA410/810 User Manual
Enable
8/63