Table of Contents
Advertisement
Locomotive basics
Installing the battery
A
lthough the LEGACY RailSounds sound system is powered through the track, you may choose
to install a nine-volt alkaline battery if you find that the sound system shuts down during
track power interruptions (for example, over a dirty section of track). Follow these steps to install
the battery.
If the RailSounds sound system turns off during interruptions in track power, you may
Note!
need to replace the battery. Use only alkaline batteries.
1. Carefully lift away the cab roof, which is held in place by two magnets.
2. Remove the protective cover from the battery harness.
3. Snap the battery harness onto the nine-volt alkaline battery's terminals.
4. Slide the battery into the battery holder.
5. Replace the roof.
Inside the cab
+
FRONT
Figure 5. Battery installation
Cab roof
Volume control knob
Battery
harness
Battery holder
9
Use a Philips
screwdriver
REAR
Advertisement
Table of Contents
