Step 2 Front Speaker Assembly - Panasonic SC-HT1000 Operation Manual

2
STEP Front speaker assembly
Supplied Accessories
Make sure you have all
the indicated components
before assembly, setup,
and connection.
Preparation
≥ To prevent damage or scratches, lay a soft cloth and perform assembly on it.
≥ For assembly, use a Phillips-head screwdriver.
1
Attach the pipe to the base.
1
Thread the speaker cable through the base.
Lessen excess speaker cable.
Cable
Groove
2
Insert the pipe.
Insert the pipe while slightly
pulling on the speaker cable.
2
Attach the stand to the front speaker.
≥There is no difference between the right and left speakers and stands.
≥Using the polyfoam included with this unit may be convenient.
Ensure the stand is fastened on straight by lightly tightening the top and
bottom screws alternately until fully tightened.
Front speaker
Polyfoam
Connection terminals
You can also attach to the upper rear of the speaker.
The height of the speaker is indicated in the diagram on the right when
attaching the stand to the upper rear or lower rear of the speaker.
10
∑ Front speaker units
Thread the speaker
cable through here.
Holes for screws
Small screws
Mounting
plate
∑ Pipes ∑ Bases
3
Secure the pipe to the base.
Ensure the screws are securely fastened by lightly tightening the left
and right side screws alternately until fully tightened. (The heads of the
screws protrude slightly even if you have fully tightened them.)
Rear side of base
The supplied stands are specially designed for
attachment to Panasonic SB-PF1000 front speakers.
Only use as indicated in this setup.
∫
Front speaker height
(Assembled diagram)
Speaker
1,138 mm 968 mm
Pipe
Base
Attached to lower
rear of speaker
For your reference
You can enjoy good acoustics by adjusting the
height of the speaker with the height of the
television so the center position of both are
approximately the same.
(Speaker height adjustment
∑ Large screws ∑ Small screws
(XSS6+14FZ) (XSN5+10FN)
Large screws
Cable
You can adjust within this range.
678 mm
Stopper
screw
796 mm 625 mm Do not remove.
Attached to upper
rear of speaker
procedure 3)