Panasonic SC-HT1500 Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Panasonic Manuals
  4. Home Theater System
  5. SC-HT1500
  6. Operating instructions manual
Panasonic SC-HT1500 Operating Instructions Manual

Panasonic SC-HT1500 Operating Instructions Manual

Hide thumbs Also See for SC-HT1500:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Operating Manual, Operating Instructions Manual

Setup Guide

Use only supplied speakers
Using other speakers can damage the unit and sound quality will be negatively affected.
A
FRONT
S
et the speakers up on an even surface to prevent them from falling over.
Take proper precautions to prevent the speakers from falling over
if you cannot set them up on an even surface.
A
The angles in the diagram are approximate.
EB
B
SURROUND
C
SUBWOOFER
A
C
D
E

Home Theater System

D
CENTER
E
MAIN UNIT
MAIN UNIT

Operating Instructions

Recordable DVD

SC-HT1500
Model No.
Caution
≥The main unit and supplied speakers are
only to be used as indicated in this setup.
Failure to do so may lead to damage to the
amplifier and/or the speakers, and may
result in the risk of fire. Consult a qualified
service person if damage has occurred or
if you experience a sudden change in
performance.
≥Do not attempt to attach these speakers to
walls using methods other than those
described in this manual.
B
B

Advertisement

Table of Contents
loading

Related Manuals for Panasonic SC-HT1500

Summary of Contents for Panasonic SC-HT1500

  • Page 1: Setup Guide

    Setup Guide Operating Instructions Recordable DVD Home Theater System SC-HT1500 Model No. Use only supplied speakers Using other speakers can damage the unit and sound quality will be negatively affected. SURROUND FRONT Caution ≥The main unit and supplied speakers are only to be used as indicated in this setup.

  • Page 2: Front And Surround Speaker Assembly

    Lessen excess The supplied stands are specially designed for attachment to speaker cable. Panasonic SB-FS1501 front speakers and SB-PS1501 surround speakers. Only use as indicated in this setup. Attach the stands to the front and surround speakers. ≥There is no difference between the right and left speakers and stands.
  • Page 3 Connect the speaker cables. ≥Twist off the vinyl ends of the speaker cable. _: Copper Push ! `: Silver Rear side of speaker Adjust the speaker height. ≥Check the screws you tightened in procedures 1-3 and 2 -3 if the pipe and speaker are loose (➡ page 2). 2 With one hand on the base, and the other 1 Loosen the attached mounting plate screw holding the speaker, adjust the height of...

  • Page 4: Setup And Connection Of Speakers

    STEP Setup and connection of speakers ∏ Surround speakers ∏ Center speaker ∏ Subwoofer ∏ Front speakers ∏ Sheet of speaker-cable ∏ Center speaker stickers cable (4 m cable) Preparation Attach the stickers to the speaker cables. For the center speaker cable (4 m cable) e.g., For the front speaker (L) cable Copper About 10 cm...
  • Page 5 Connect the speaker cables to the subwoofer. Speaker-cable sticker 2 FRONT (R) 1 FRONT (L) 4 SURROUND (R) 3 SURROUND (L) SUBWOOFER 5 CENTER Push ! Insert the wire fully. Copper Push! Silver [Note] ≥Never short-circuit positive (i) and negative (j) speaker wires. ≥Be sure to connect only positive (copper) wires to positive (i) terminals and negative (silver) wires to negative (j) terminals.

  • Page 6: Video Connections

    Q Link offers a range of convenient functions (For further details ➡ Operations Guide, page 55). Make sure to connect a fully wired 21-pin Scart lead to the television if using the Q Link function. The following systems from other manufacturers have similar functions to Q Link from Panasonic. For details, refer to your television’s operating instructions or consult your dealer.
  • Page 7 ∏ RF coaxial lead ∏ Video cable ∏ Main unit indicates included accessories. indicates accessories not included. Connecting a television with 21-pin Scart terminal and Satellite receiver ≥When there is no 21-pin Scart terminal on the television (➡below or page 8). ≥Change the “AV2 Input”...
  • Page 8 STEP Video connections indicates included accessories. indicates accessories not included. Connecting a television with VIDEO, S-VIDEO or COMPONENT VIDEO terminals and VCR Connecting to the television using the 21-pin Scart leads (➡page 7). To the aerial Television VIDEO IN S-VIDEO IN COMPONENT VHF/UHF VIDEO IN...

  • Page 9: Radio And System Connection

    STEP Radio and system connection ∏ System cable ∏ AM loop aerial ∏ FM indoor aerial ∏ AC mains leads Connect the aerials. Connect the AC mains leads. (Optional FM aerial connection➡ Operations Guide, page 45) BE SURE TO READ THE CAUTION FOR THE AC MAINS LEAD ON PAGE 2 IN OPERATIONS GUIDE BEFORE CONNECTION.

  • Page 10: Channel Reception Settings

    STEP Channel reception settings When downloading has been completed, the Owner ID settings Í/I screen appears. VOLUME OPEN/CLOSE Press [1] and press the numbered buttons TUNE TIME SLIP INPUT SELECTOR PULL-OPEN FM/AM DOWN to enter a 4-digit PIN number. Owner ID HOME THEATER HOME DISPLAY...
  • Page 11 (When connecting to a television with RF socket only) Í/I CHX, CHW Set the new RF output channel to TV (refer to the instructions for your TV). Select an unused channel pre-set on your TV and tune it to the RF VOLUME OPEN/CLOSE output channel number shown on the unit’s display.

  • Page 12: Other Speaker Setup Options

    1 Thread the string (not included) through the slot on the rear of the front and surround speakers to prevent them from falling over. Rear side of the speaker 2 Loop the string through the screw eye and tie tightly. Matsushita Electric Industrial Co., Ltd. Web Site: http://www.panasonic.co.jp/global/ RQT7627-B F0604TJ0...

Table of Contents