Simple Setup; Front And Surround Speaker Assembly - Panasonic SC-HT928 Operating Instructions Manual

Simple setup

1
STEP

Front and surround speaker assembly

[Note]
The front and surround speaker pairs as well as the pipe pairs are
different.
– Check the label on the rear of the speaker before attaching the
pipe (‹page 6).
– The pipe with the shorter cable is for the front speaker unit.
Preparation
≥To prevent damage or scratches, lay down a soft cloth and
perform assembly on it.
≥For assembly, use a Phillips-head screwdriver.
1
Attach the pipe to the base.
1 Thread the speaker cable through the base.
Lessen excess speaker cable.
Groove
2 Insert the pipe.
Insert the pipe while gently
pulling on the speaker cable.
3 Secure the pipe to the
base.
Ensure the screw is
securely fastened.
The supplied stands are specially designed for attachment
to Panasonic SB-PF921 front speakers and SB-PS921
surround speakers. Only use as indicated in this setup.
2
Attach the stands to the front and
surround speakers.
≥There is no difference between the right and left speakers and stands.
≥Using the polyfoam included with this unit may be convenient.
1 Remove the screw and separate the mounting plate into
two parts.
RQT7436
4
Make sure you have all the indicated components before starting assembly, setup, and
connection.
4 bases
Thread the
speaker cable
Cable
through here.
Hole for screw
Rear side of base
Cable
Plate B Plate A
Small screw
2 front and
4 pipes
2 surround
speaker units
2 Attach plate A to the speaker.
Ensure that plate A is fastened on straight by lightly tightening the
top and bottom screws alternately until fully tightened.
Speaker
Polyfoam
You can also attach to the upper rear of the speaker.
The height of the speaker is indicated in the diagram
(‹ page 5) when attaching plate A to the upper rear or lower
rear of the speaker.
3 Place the pipe on plate A and attach plate B.
Plate B
Large
washer
screw
4 Secure the plate with the same screw removed in
procedure 1.
4 large washer 4 mounting plates
screws
8 small screws
Small screws
Plate A
Rotate the pipe so that the flat
side is facing away from the
back of the speaker.
Fit the offset into the slot
and slide plate B into the
locked position.
Plate B
Offset
Slot
Small screw